Skip to main content

This may be the latest post

Getting Started With ATTINY88 DEV BOARD

  Hay Everyone, I this blog I'm going to show how you can use ATTINY88 Arduino nano compatible development board with Arduino ide on Ubuntu operating system. YT VIDEO LINK : https://youtu.be/te3z6Wy6Adk First of all you have to add the Arduino core for attiny88 to your board's List. To do that copy the below link and paste it to your Arduino IDE location: File/Preference/Additional boards. Link : https://raw.githubusercontent.com/MHEtLive/arduino-boards-index/master/package_mhetlive_index.json After pasting click on OK to close the window and then Ok to close the Preference window, you will see a little notification will appear on the bottom right corner on your IDE which is detecting location you added. Go to your boards manager (Click on Tools/Boards/Boards Manager) and start typing in the search line like "MH-ET LIVE BOARDS" As shown in the image, install it and then open simplke LED blink code by clicking on the Files/Examples/Basic/Blink. Then go to Tools/Boa...
Post a Comment
click to know more...
Labels

How to make Tiniest Rechargeable Fan With 29 MAh Rechargeable LI-PO Battery

How to make Tiniest Rechargeable Fan     

 


















Hello viewers,

In this Project i will show how I made the world's smallest table fan with a rechargeable battery . The above video link consists working of the world's smallest table fan which has 29 Mah rechargeable lipo battery in it and good speed.

Length of this fan is -- 11mm/1.1cm

Width of this fan is -- 11mm/1.1cm

Height of this fan is -- 22mm/2.2cm

This is smaller than the Asia book of world record holder(that one was without battery).

Part-2 of this video will contain full build process and timelaps of this fan.

Part 1 link -- https://youtu.be/NxKDEtt_VOo

Part 2 link -- https://youtu.be/k9G6JOv4xFk?si=g1Qej3js_Dc8vsqQ
Materials :
1x small dc motor, 1x small lipo battery, on/off switch ,Some plastic strips and thin pipe, super glue ,some wires,soldering iron,soldering paste,soldering wire,cutter,scissor,permanent marker(for colour).



Step 1 - Battery Box and Connection


I made a battery box with switch and wires are also connected.

Battery positive to motor positive, Battery negative to One side of switch, Motor negative to opposite side of the switch. And other two pins for charging the battery.



Step 2: Structure
I changed the disk motor because that was stucked(with super glue) ,with a micro motor. Covered the battery box and joint the motor with the box by using thin plastic tube and glue.

Step 3: PropallerA small tube inner diameter is larger than the motor diameter with a motor shaft whole is made for the propaller and cutted 3x band plastic pieces for the prop blades and joint them with the tube with glue.








Step 4: Detailing and Measuring

Coloured with permanent marker and signed 'ELECOBOT"

It's looking little different but works pretty well.High speed and long battery life with 29 mah battery.





Labels:

Comments

Post a Comment

Most popular